Special attention should be paid to the problems in the installation of the barbed wire machine:

Between 1 host big gear and the big gear of the auxiliary machine bite, barbed wire machine is two occlusal gear must be aligned between two teeth can not be completely to bite a certain gap exists, the reason is not completely occlusion resistance operation of the machine when the machine will run a certain gap with relative ease.

2 host and auxiliary equipment and the ground to fit to maintain the level with the ground.

3 barbed wire machine has 8 anchor bolt holes to play 3 holes in the ground, 350mm deep hole hole width and length and the size of machine to the ratio of casting is careful not to do when there is leakage of cement.

Barbed wire machine to get the latest technology will come out with a new production capacity. For a long time the barbed wire machine operator is the most headache thing is part of both technology and the host auxiliary cable cutter. Cable problem has been solved. In order to solve the difficult problem in the improvement of the use of technology in Korea I plant, developed a perfect combination of slot knife and cutter, barbed wire machine users only need to put the props in the fixed area will pressure knife screws are tightened, very easy to use and fast, the majority of customers come to order.